NEC DS1000 Quick Setup Manual page 16

Section 1: Start-up Programming
6. Enter 201 + HOLD twice. You see:
9902:SLOT:n:nASTU
PORT:nn STATION:nnn
7. Press VOL Up , then repeat step 6 to assign additional Voice Mail stations (202-208) to the remaining
installed Voice Mail ports.
8. Press CONF to go back to step 4.
Press CONF twice to go back to step 3 and select another slot to program.
Press CONF three times to exit program 9902.
For Digital VANGARD
Each Digital VANGARD connection is a two-channel device that represents two Voice Mail ports (stations).
In programming, you assign a separate Voice Mail station (201-208) to each channel. The first channel is
called the primary station; the second channel is called the secondary station.
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter 9902 + HOLD . You see:
9902:STATION CARDS
SLOT?
3. Enter the slot number (1-8) which contains the DSTU PCB to which your digital Voice Mail is con-
nected + HOLD . You see:
9902:SLOT:n:16DSTU
V-RMV/P-PORTS/X-SWAP
4. Enter P (7). You see:
9902:SLOT:n:16DSTU
PORT:nn PRI STA?:nnn
5. Press VOL Up until you select the primary station for the first (lowest numbered) port to which your
Digital VANGARD is connected.
6. Enter 201 + HOLD twice. You see:
9902:SLOT:n:16DSTU
PORT:nn PRI STA?:201
7. Press VOL Up . You see:
9902:SLOT:n:16DSTU
PORT:nn SEC STA?:UND
8. Enter 202 + HOLD twice. You see:
9902:SLOT:n:16DSTU
PORT:nn PRI STA?:201
9. Repeat steps 6-8 to assign Voice Mail stations to the remaining installed Digital VANGARD Voice
Mail ports.
10. Press CONF to go back to step 4.
Press CONF twice to go back to step 3 and select another slot to program.
Press CONF three times to exit program 9902.
1-12 ◆ Section 1: Start-up Programming
OR
OR
OR
OR
DS1000/2000 Quick Setup Guide