Do you have a question about the BOLT 57720 and is the answer not in the manual?
Questions and answers
sandy ruxton
January 22, 2025
I have a Halo Bolt 57720 that I have never used...it's at least 5 years ago. I'm having some challenges with charger the Bolt. I get only 1 green blinking light. And when I plug in the cables there is a light that quickly goes off.
1 comments:
Mr. Anderson
February 10, 2025
If your HALO BOLT 57720 only shows a blinking green light, refer to the power level indicators for charging. A blinking green light indicates that the device is charging, with the number of solid and blinking lights showing the current charge level:
- First light blinking: 0%-25% charged. - First light solid, second light blinking: 26%-50% charged. - First two lights solid, third light blinking: 51%-75% charged. - First three lights solid, fourth light blinking: 76%-99% charged.
Ensure the device is connected to a working AC adapter and wall outlet. If the blinking persists and the charge level does not increase over time, check the adapter and cable for damage and try a different outlet. Fully charging the device can take up to 6 hours. If the issue remains unresolved, the device may require professional inspection.
Page 2
HALO BOLT 57720 Powerful, compact and easy to use, the HALO BOLT can safely jump start your car. In addition, you can use it to charge your phone, tablet or other electronic devices! The HALO BOLT also features a convenient LED floodlight.
OPERATING INSTRUCTIONS GETTING STARTED Prior to first use, it is recommended to fully charge the HALO BOLT 57720. CHARGING THE HALO BOLT 57720 To recharge the HALO BOLT, use the provided AC wall charging adapter cable, and plug the AC adapter tip into the charge input.
When your HALO BOLT 57720 is on, the LED indicator lights will display the power level. HALO BOLT 57720 POWER LEVEL INDICATORS INDICATOR LIGHTS HOW TO READ AMOUNT OF CHARGE One solid light 0%-25% Two solid lights 26%-50% Three solid lights...
Do not touch red (positive) and black (negative) clamps together at any point. If the jump start button flashes red, the jumper cables have been connected incorrectly. If this flashing red condition occurs, disconnect the jumper cables from the HALO BOLT and vehicle battery and restart the process from step 1.
Page 8
4. Start your vehicle NOTE: The HALO BOLT will allow 3 consecutive jump start attempts after each time you press the jump start button. You must allow up to 15 seconds between each jump start attempt. During the 15 seconds, the jump start button will flash green while the HALO BOLT performs its safety checks.
(-) Check the jumper cables HALO BOLT Jump The HALO Bolt is waiting to and ensure they are Start button flashes be connected to a battery. properly connected to the green continuously battery.
2. Turn on the USB charging feature by pressing and releasing the Power ON/OFF Button on the HALO BOLT NOTE: The HALO BOLT USB charging feature will automatically power off after 5 minutes of inactivity. While jump starting your vehicle, you cannot charge your electronic devices and/or you cannot charge the HALO BOLT via the AC wall charging adapter.
HALO SMART CHARGE TECHNOLOGY Your HALO BOLT contains the HALO SMART CHARGE TECHNOLOGY to achieve higher compatibility for charging standard 5V USB electronic devices. The HALO SMART CHARGE TECHNOLOGY will determine the make and model of your electronic device and provide the fastest and safest charge for that device.
- Do not disassemble or attempt to repair your HALO BOLT yourself. - Use a soft cloth with soap to clean the exterior of your HALO BOLT. Do not use liquid detergent or chemicals of any kind on your HALO BOLT.
Page 13
- Do not expose your HALO Bolt to moisture, water, rain, or snow. - Do not insert any object into the ports or openings of your HALO Bolt. - Never leave your HALO Bolt unattended while charging.
SPECIFICATIONS Battery Cell: 3 x Li-Polymer 5200mAh(1 Battery Pack 57720 mWh) Capacity: 57720 mWh Input: DC 14V/0.85A Output: 2 x USB 5V/2.4A Dimensions: 6.97”x 3.68”x 1.5” (177 x 93.5 x 38mm) FCC COMPLIANCE STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: - This device may not cause harmful interference, and - This device must accept any interference received, including...
Page 15
Halo International standard warranty, a 2 year extended warranty is available through Good Housekeeping for any HALO BOLT 57720 purchased in the USA. If the product proves to be defective within two years from the date it was first sold, Good Housekeeping, will repair or replace the product or refund the purchase price at Good Housekeeping's sole discretion.
Page 16
Limited Warranty HALO will repair or replace the product, at its sole option, without charge. When repair- ing or replacing a product, HALO may, at its sole option, repair or replace the product with new, used, rebuilt or reconditioned parts or products.
Page 17
How does state law relate to this limited warranty? Some states do not allow limitation on how long an implied warranty lasts or the disclaimer or limitation of incidental or consequential damages. Therefore, some or all of the declaimers and limitations above may not apply to you.
888-907-6274 Halo International SEZC Ltd. 68 West Bay Road Georgetown, Grand Cayman, KY1-1003 Cayman Islands The HALO logo is a registered trademark of HALO2CLOUD, LLC www.BESTHALO.com Designed by HALO International SEZC Ltd. Patent Pending Made in China...
Need help?
Do you have a question about the BOLT 57720 and is the answer not in the manual?
Questions and answers
I have a Halo Bolt 57720 that I have never used...it's at least 5 years ago. I'm having some challenges with charger the Bolt. I get only 1 green blinking light. And when I plug in the cables there is a light that quickly goes off.
If your HALO BOLT 57720 only shows a blinking green light, refer to the power level indicators for charging. A blinking green light indicates that the device is charging, with the number of solid and blinking lights showing the current charge level:
- First light blinking: 0%-25% charged.
- First light solid, second light blinking: 26%-50% charged.
- First two lights solid, third light blinking: 51%-75% charged.
- First three lights solid, fourth light blinking: 76%-99% charged.
Ensure the device is connected to a working AC adapter and wall outlet. If the blinking persists and the charge level does not increase over time, check the adapter and cable for damage and try a different outlet. Fully charging the device can take up to 6 hours. If the issue remains unresolved, the device may require professional inspection.
This answer is automatically generated
Keep getting message battery check fail
@Carol scholl