Table of Contents
Advertisement
11
Reading (X) and Resetting (Z)
of Sales Totals
• Use the reading function (X) when you need to take the reading of sales information entered
after the last resetting. You can take this reading any number of times. It does not affect the
POS terminal's memory.
• Use the resetting function (Z) when you need to clear the POS terminal's memory. Resetting
prints all sales information and clears the entire memory except for the GT1 thru GT3, reset
count, and consecutive number.
• X1 and Z1 reports show daily sales information. You can take these reports in the X1 or Z1
mode.
• X2 and Z2 reports show periodic (monthly) consolidation information. You can take these
reports in the X2 or Z2 mode.
■ How to take a reading (X1, X2) or resetting (Z1, Z2) report
[To take a reading (X1 or X2) report]
1. Select "X1 MODE" or "X2 MODE" in the mode menu window to display the items list.
2. Select an item listed in the table shown later.
3. If needed, enter corresponding values described in the "Data to be entered" column on the table
shown later.
4. Select a device ("DISPLAY" or "REPORT PRINTER") to receive the output.
[To take a resetting (Z1 or Z2) report]
1. Select "Z1 MODE" or "Z2 MODE" in the mode menu window to display the items list.
2. Select an item listed in the table shown later.
3. If needed, enter corresponding values described in the "Data to be entered" column on the table
shown later.
4. Select a device ("DISPLAY" or "REPORT PRINTER") to receive the output.
The message "ARE YOU SURE ?" will appear. Take one of the following actions:
• Select "YES" to take a resetting (Z1, Z2) report.
• Select "NO" to cancel the generation of a resetting (Z1, Z2) report.
When a secret code has been set for the corresponding report, enter the secret code and press
NOTE
the
key.
ENTER
OPXZ MODE
X1 MODE
Z1 MODE
X2 MODE
Z2 MODE
53
Advertisement
Table of Contents
