Tilt Control Screws; Keyboard; Inserting The Keyboard Sheet - Sharp ER-A771 Instruction Manual

Tilt control screws

1. Loosen the outer screw.
2. Adjust the height of the inner screw.
3. Tighten the outer screw to fix it.

Keyboard

Inserting the keyboard sheet

Insert the keyboard sheet between the keyboard cover and the cabinet as illustrated below.
NOTE
• Do not spread the keyboard cover
too far to avoid tearing the tabs.
• Replace the keyboard sheet with a
new one if by chance it gets wet.
Use of a wet keyboard sheet may
cause problems.
• Be sure to use only SHARP-supplied keyboard
sheets. Thick or hard sheets may make key
operation difficult.
• Insert the keyboard sheet evenly under the
keyboard cover, without any folds or wrinkles, to
ensure easier operation.
• If you require a new keyboard sheet, please contact your dealer.
• The keyboard cover will eventually wear out. If your keyboard cover is dirty or broken, replace the cover
with a new one. For details, please contact your authorized SHARP dealer.
8
These lines can be used to measure the height of the screw.
Keyboard cover
Keyboard sheet
Cabinet