Before You Start; Setting The Clock & Day - Danfoss TP5000 + RF Installation Instructions Manual

Before you start

Open the fl ap on the front of the
programmer.
Press the + & – AND
simultaneously to reset the unit.
This will reinstate the preset programmes
and will set the time to 12:00 on Day 1 and
the temperature to 20°C.
Setting the Clock & Day
Note: clock is displayed in 24 hour mode.
CLOCK
Press PROG to begin programming.
Use + or - to adjust the TIME (press and
hold to change in 10 min increments).
DAY
Press PROG again.
Use + or - buttons until correct DAY is
shown (1 = Monday, 2 = Tuesday, etc).
!
Remember - you will have to reset
the time when the clocks change in
Spring and Autumn.
& buttons
i2 00
GB
9