Danfoss TP5000 Si User Instructions

TP5000 Si/TP5000 RF Si
User Instructions
Before programming the thermostat press and release the RESET button to restart
the unit. (Fig. 1)

Setting the Clock and Day

The day and time are set in the factory and therefore it will not normally be necessary
to do this on site. Changes between summer and winter time are handled automatically
by the unit.

Accepting the Factory Pre-settings

The TP5000 Si has pre-set times already programmed in, which often suit most people
(see table below).
Note: If set up for 4 events per day, events 3 & 4 are skipped. If set up for 2 events per
day, events 2, 3, 4 & 5 are skipped and the events are re-numbered.
Mon-Fri
Event Time
1 06:30
2 08:30
3 11:30
4 13:30
5 16:30
6 22:30
To adjust the factory pre-settings & set your own time and temperature
programmes
For Days 1-5 (weekdays)
a) Press PROG (Fig. 2) until the 1
(Fig. 3).
b) Use + or – buttons (Fig. 4) to adjust the TIME (press and hold to change in 10 min
increments).
c) Use Λ or V buttons (Fig. 5) to adjust the TEMPERATURE.
d) Press PROG (Fig. 2) to move to next preset time & temp (Event 2) (Fig. 6).
e) Repeat steps b, c & d for programming Events 3, 4, 5 & 6.
For Days 6-7 (weekends)
• Press PROG (Fig. 2) to show 1
(Fig. 7).
• Repeat steps b, c and d above to programme time and temperature events for
the weekend.

Returning to RUN mode

Press PROG (Fig. 2) – the colon in the LCD display will start to flash (Fig. 8).

Complete Shut off - Summer time

Press Λ and V together to enter thermostat mode. A frost protection symbol (snowflake in a
shield) will appear in the display . Press the down arrow ∨ once, OFF will appear in the display.
To return to automatic programming press both ∧ and ∨ together.
Sat-Sun
Temp. °C Event
20 1
15 2
20 3
15 4
21 5
15 6
st pre-set time and temperature (Event 1 Days 1,2,3,4,5)
pre-set time and temperature (Event 1 Days 6-7)
st
Time Temp. °C
07:30 20
09:30 20
11:30 20
13:30 20
16:30 20
22:30 15
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
Fig.8
RESET