Canopy T1/E1 Multiplexer
2.4.5
Configure Ports
Procedure 10: Configuring the Ethernet ports using the CLI
Perform this procedure to configure the Ethernet ports using the CLI manager.
NOTE: Both Ethernet ports operate at 100 Mbps Full Duplex. They will not operate at
10 Mbps or at half duplex.
Action
Log in
Set BH-side Ethernet auto-
negotiation
Set LAN-side Ethernet
auto-negotiation
Log off
Issue 3
Press Enter.
At the username prompt, enter admin.
At the password prompt, enter password.
Enter set canopy port auto negotiation [on/off]
where
on enables auto negotiation at 100 Mbps Full Duplex (as default).
off forces the port to 100 Mbps Full Duplex without auto negotiation.
RESULT: The system responds
Canopy port auto-negotiation is: on
Enter set lan port auto negotiation [on/off]
where
on enables auto negotiation at 100 Mbps Full Duplex (as default).
off forces the port to 100 Mbps Full Duplex without auto negotiation.
RESULT: The system responds
LAN port auto-negotiation is: on
Enter lo.
RESULT: The system responds goodbye.
end of procedure
Page 39 of 73
T1/E1 Multiplexer FPGA Version 3.4
Steps
September 2004