Table of Contents
Advertisement
Canopy T1/E1 Multiplexer
2.3.3
Accessing the CLI using a PC + HyperTerminal
The Command Line Interface (CLI) is accessed using a PC with that includes a terminal
emulation package such as HyperTerminal
NOTE: The device is only accessible through the serial port.
2.3.4
Configuring the Canopy T1/E1 Multiplexer using the CLI
Before you use the CLI to configure the Canopy T1/E1 Multiplexer, you must configure
the PC serial port.
Use this procedure to access the CLI using a terminal emulation program such as
HyperTerminal.
1. Connect the serial cable from the DB9 serial port on a PC to the Serial port on
the Canopy T1/E1 Multiplexer. The DB9 connector on Canopy T1/E1 Multiplexer
is female; the cable from the PC is male. A straight-through cable is required.
2. Start HyperTerminal or another terminal emulation program.
3. Set the terminal emulation program to emulate a VT100 terminal with the
following settings:
4. Press Enter.
The Canopy T1/E1 Multiplexer Login menu is displayed.
RESULT: The signal port is configured.
To use the CLI, select Command Line Interface terminal from the File drop-down menu
(illustrated in
Figure 14
shown in
Figure
Issue 3
Procedure 6: Configuring serial port
®
Parameter
Bits per second
Data bits
Parity
Stop bits
Flow control
end of procedure
on Page 33). The Command Line Interface window opens, as
16.
Page 34 of 73
T1/E1 Multiplexer FPGA Version 3.4
®
.
Value
19200
8
none
1
none
September 2004
Advertisement
Table of Contents
