Starter Drive One-Way Clutch Removal And Inspection; Balance Shaft Sprocket Removal And Inspection - Polaris RANGER RZR 170 Service Manual

ENGINE
5. Inspect sprocket teeth of both gears for wear or
damage.
Inspect for Areas of
Tooth Wear or Damage
6. Inspect woodruff key for wear. Replace if damaged.
7. Replace any worn or damaged parts.
Starter Drive One-way Clutch 
Removal and Inspection
1. The cooling shroud, stator housing and flywheel must
be removed prior to accessing the one-way starter
drive.
2. Pull the starter drive assembly from the crankshaft.
Inspect the bearing surfaces and drive teeth for signs
of wear or gouging. Replace the one-way clutch as an
assembly if it is not working properly. Assembly should
turn in one direction only.
One-way Assembly
Drive Gear
NOTE: One-way clutch
serviceable. Replace
assembly.
3. Do not add specialized lubricants or greases to the
bearing or one-way components, as this may cause
undesirable operation.
3.30
Bearing
components are
the component as
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
Balance Shaft Sprocket 
Removal and Inspection
1. The cooling shroud, stator housing and flywheel and
starter drive one-way gear must be removed prior to
accessing the balance shaft gear and oil pump gear
2. Using Slotted Nut Socket PA-47344, remove the
balance shaft slotted nut and washer.
NOTE: Slotted nut is right-hand thread.
Remove
A
PA-47344
Install
Slotted Nut Socket
not
an
E
D
PA-47344
C
B
PA - 47344
C