Motorola GP68 Installation And Operation Manual page 21

Example #3:
Table 2-1 illustrates a possible programming/activation scenario. The first three
subscribers are individual subscribers using half duplex type equipment. These
paging codes will be programmed into only one piece of subscriber equipment in
the Primary Code position. The fourth and fifth entries are group subscribers. The
group paging code may be programmed into many pieces of subscriber equipment
as Primary Code or Secondary Code (Group/Sub-Group).
Table 2-2 depicts how four pieces of user equipment may be programmed
related to Table 2-1.
Subscriber Equipment #1
Subscriber Equipment #2
Subscriber Equipment #3
Subscriber Equipment #4
If a subscriber primarily has only radio dispatch/fleet
requirements, both the Primary Code and the Second-
ary Codes may be assigned to group Paging Codes.
When programmed in this manner, the equipment will
respond to two groups (Group and Sub-Group). The
operator of this equipment can only receive Group or
Sub-Group calls. An individual user in the subscriber
group can make individual outgoing calls to the landline
(Primary Code is used).
10000
10001
10003
90000
90001
2 • Operating Modes
half
half
half
group
group
will operate as an individual user.
will operate as an individual and be
grouped with #4.
will operate as an individual, with
grouping to #4 but NOT grouped with
#2.
operates with two groups. Thereby
being associated with #2 and #3.
4100
4101
4102
4103
4104
21