Suzuki 2006 SX4 Service Manual page 34

0B-3 Maintenance and Lubrication:
Severe
condition code
Manual transaxle oil
– B – – E – – H Transfer oil (4WD)
Differential oil (4WD)
– B – – E – – H Automatic transaxle fluid
– – C D – – – – HVAC air filter (if equipped) *2
NOTE
• "I": Inspect and correct or replace if necessary
• "R": Replace or change
• *1: Inspect or replace more frequently if the vehicle is used under dusty conditions.
• *2: Clean or replace more frequently if the air from the air conditioning decreases.
Accessory Drive Belt Inspection
WARNING
!
All inspection and replacement are to be
performed with ENGINE NOT RUNNING.
Water Pump and Generator Drive Belt
Inspect belt for cracks, cuts, deformation, wear and
cleanliness. If any defect exists, replace.
Check belt for tension referring to "Water Pump /
Generator Drive Belt Tension Inspection and Adjustment
in Section 1J".
A/C Compressor Drive Belt (If Equipped)
Inspect belt for cracks, cuts, deformation, wear and
cleanliness. If any defect exists, replace.
Check belt for tension referring to "Compressor Drive
Belt Inspection and Adjustment in Section 7B" or
"Compressor Drive Belt Inspection and Adjustment in
Section 7B".
Accessory Drive Belt Replacement
Water Pump and Generator Drive Belt
Replace belt with new one referring to "Water Pump /
Generator Drive Belt Removal and Installation in Section
1J".
A/C Compressor Drive Belt (If Equipped)
Replace belt with new one referring to "Compressor
Drive Belt Removal and Installation in Section 7B" or
"Compressor Drive Belt Removal and Installation in
Section 7B".
Maintenance
Repair Instructions
S6RW0D0206001
S6RW0D0206002
Maintenance
operation
First time only:
15,000 km (9,000 miles) or 12
months
/ / R Second time and after:
Every 30,000 km (18,000 miles) or
24 months reckoning from 0 km (0
mile) or 0 month
R Every 30,000 km (18,000 miles) or
24 months
Every 15,000 km (9,000 miles) or
I
12 months
Every 45,000 km (27,000 miles) or
R
36 months
Valve Lash (Clearance) Inspection
Inspect intake and exhaust valve lash and adjust as
necessary.
Refer to "Valve Lash (Clearance) Inspection in Section
1D" for valve lash inspection and adjustment procedure.
1. Camshaft
Maintenance interval
S6RW0D0206003
I2RH0B020003-02
2. Thickness gauge