Kubota L3540 Workshop Manual page 281
Hide thumbs
Also See for L3540:
- Operator's manual (17 pages) ,
- Operator's manual (157 pages) ,
- Operator's manual (147 pages)
Table of Contents
Advertisement
L3540, L4240, L5040, L5240, L5740, WSM
Electrical Wiring
1. Remove the shield LH (3). (If equipped)
2. Disconnect the wiring connectors for a alternator (1), coolant
temperature sensor (7), oil pressure switch (4), fuel sensor (2),
starter motor (5) and battery (6).
3. Remove the ground cable (8) of wiring harness.
4. Remove the harness bracket with wiring harness.
(1) Alternator
(2) Fuel Sensor
(3) Shield LH
(4) Oil Pressure Switch
Panel Cover
1. Remove the floor mat.
2. Remove the steering post cover 2 (3), and disconnect the shuttle
switch connector (4). [Manual Transmission and GST Model]
3. Remove the steering post cover 1 (2) and panel cover (1).
(1) Panel Cover
(2) Steering Post Cover 1
3-S44
TRANSMISSION
(5) Starter Motor
(6) Battery
(7) Coolant Temperature Sensor
(8) Ground Cable
W1293536
(3) Steering Post Cover 2
(4) Shuttle Switch Connector
W1019247
KiSC issued 04, 2010 A
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the L3540 and is the answer not in the manual?
Questions and answers
We're is the block heater located on an L5240 and when do I need to plug it in
Where is the heater plug located on L5240 and what temp to plug it in