Kubota L3540 Workshop Manual page 124

L3540, L4240, L5040, L5240, L5740, WSM
Draining the Transmission Fluid
CAUTION
• Allow the engine to cool down sufficiently, oil can be hot and
burn
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs.
3. Drain the transmission fluid completely.
4. Reinstall the drain plugs.
(When refilling)
• Fill up from filling port after removing the filling plug (3) until
reaching the upper notch on the dipstick (4).
• After running the engine for few minutes, stop it and check the oil
level again, add the fluid to prescribed level if it is not correct
level.
L3540
Transmission fluid
L4240
capacity
L5040, L5240, L5740
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
(Refer to "4. LUBRICANTS, FUEL AND COOLANT" at "G.
GENERAL" section.)
• Do not mix different brands of fluid together.
(1) Drain Plugs
(2) Drain Plug (Manual Transmission
Type)
(3) Filling Plug
(4) Dipstick
1-S24
ENGINE
42 L
11.1 U.S.gals
9.2 Imp.gals
43 L
11.4 U.S.gals
9.5 Imp.gals
45 L
11.9 U.S.gals
9.9 Imp.gals
(a) Oil level is acceptable within this
range.
W1014221
KiSC issued 04, 2010 A