Changing Blades - DeWalt DCS391 Instruction Manual

M
FIG. 2
C
FUEL GAUGE BATTERY PACKS (FIG. 2A)
Some D WALT battery packs include a fuel gauge which consists of
E
three green LED lights that indicate the level of charge remaining in
the battery pack.
To actuate the fuel gauge, press and hold the fuel gauge button (R).
A combination of the three green LED lights will illuminate designating
the level of charge left. When the level of charge in the battery is below
the usable limit, the fuel gauge will not illuminate and the battery will
need to be recharged.
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate tool functionality and is subject to
variation based on product components, temperature and end-user
application.
For more information regarding fuel gauge battery packs, please
contact your local service center.
FIG. 2A
R
54
Trigger Switch (Fig. 3)
WARNING: This tool has no
provision to lock the trigger switch
in the ON position and should never
be locked ON by any other means.
Release the trigger switch lock-off
button (A) by pressing the button
as shown. Pull the trigger switch (B)
to turn the motor on. Releasing the
trigger switch turns the motor off.

Changing Blades

(Fig. 4, 5)
TO INSTALL THE BLADE (FIG. 4, 5)
1. Place inner clamp washer (O) on saw spindle with the large flat
surface facing out toward the blade (Fig. 4A, 4B).
FIG. 4A
K
F
O
H
P
2. Retract the lower blade guard (G) and place blade on saw spindle
against the inner clamp washer, making sure that the blade
FIG. 3
A
B
L
G