Name/Function Of Each Part - Sanyo HEC-DR5700 Instruction Manual

NAME/FUNCTION OF EACH PART (continued)
Body areas that can be massaged.
Areas where stiffness has been detected.
Shoulder position measurement /
Original position display
The "SHOULDER" icon flickers when the figure
(the shoulder position) is being measured, and
"ADJUST" lights up when the measurement is over.
Illuminates if the fingers (hand) are not
placed on the sensor during a measurement
of stiffness in the Whole Body Sensor
Automatic Courses.
WHOLE BODY SENSOR
AUTOMATIC COURSE display
Turns on during a Whole
Body Sensor Automatic
Course. ( flickers)
does not light up if
the fingers (hand) are not
placed on the sensor.
MASSAGE OPERATION
display
Displays the operation of the
current massage technique.
SOLE WARMER display
Turns on when the sole heater
is on.
Sensor controller
RECLINING buttons
Adjusts the angle between the
back rest, seat and the foot rest.
The back rest and foot rest are
moved in conjunction with each
other.
Repeat button
If this button is pressed during
Whole Body Sensor Automatic
Courses or Automatic Courses,
the current massage will be repeated
once.
Sensors
The degree of perspiration is
measured if the fingers are placed
on the sensors during a Whole
Body Sensor Automatic Course.
7
STIFFNESS display
The right side of the lamp indicates the degree of
stiffness, and the left side of the lamp indicates
the degree of relaxation.
The more the right side of the lamp is illuminated,
the higher the degree of detected stiffness.
(Remote control display)
TWIST AIRBAG DISPLAY
Blinks during twist airbag
operation.
Remote power switch
Remote control can be used to turn
on this remote power switch after
turning on the POWER switch on
the main unit.
＊The remote power switch cuts the
power supply after approximately
3 hours since you turned on the
switch.
REPEAT! display
Turns on during Whole Body Sensor
Automatic Courses and Automatic Courses.
The ring lights up by pressing the REPEAT!
button when you want to repeat your
desired massage during the course of
massaging.
While the degree of stiffness is being
measured in a Whole Body Sensor
Automatic Course, the result
is displayed with the color
of the ring.
Green: Relax
Orange: Slight degree of stiffness
No display: High degree of stiffness
MASSAGE ADJUST display
Displays the adjusted level of the strength
and speed of massaging and the width
of massaging rollers.
When these displays turn on, you can
adjust them with each adjust button.