1
a
a
1
1
1
a
b
4-5
CARBURETOR
CHOKE CABLE INSTALLATION
1. Install:
9 Choke cable
NOTE:
Push the choke knob 1 entirely in before
installing it to the panel.
2. Install
9 Choke cable 1
3 Nm (0.3 m · kg, 2.2 ft · lb)
NOTE:
Be sure install the choke cable end cap push
out a 3mm (0.118 in) form the holder.
3. Install:
9 Inner cable 1
1 Nm (0.1 m · kg, 0.7 ft · lb)
NOTE:
Place the carburetor choke valve in its fully
open position a, insert the tip of the inner
cable into drum hole, and then secure it in
place with the screw.
THROTTLE CONTROL MOTOR
1. Install:
9 Throttle control motor 1
NOTE:
9 Install the shaft a of the throttle control
motor by aligning it with the groove b of the
throttle shaft.
9 Install the throttle valve, and then make sure
that is moves smoothly.
CARB