Installation - Kenwood KMM-361SD Instruction Manual

Warning
• The unit can only be used with a 12 V DC power supply, negative
ground.
• Disconnect the battery's negative terminal before wiring and
mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to
the car chassis or Ground wire (black) to prevent a short circuit.
• Insulate unconnected wires with vinyl tape to prevent a short
circuit.
• Be sure to ground this unit to the car's chassis again after

installation.

Caution
• For safety's sake, leave wiring and mounting to professionals.
Consult the car audio dealer.
• Install this unit in the console of your vehicle. Do not touch the
metal parts of this unit during and shortly after use of the unit.
Metal parts such as the heat sink and enclosure become hot.
• Do not connect the [ wires of speakers to the car chassis or
Ground wire (black), or connect them in parallel.
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition
terminal, connect Ignition wire (red) to the terminal on the
vehicle's fuse box which provides 12 V DC power supply and is
turned on and off by the ignition key.
• After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
• If the fuse blows, first make sure the wires are not touching car's
chassis, then replace the old fuse with one that has the same rating.
Basic procedure
1
Remove the key from the ignition switch, then
disconnect the [ terminal of the car battery.
2
Connect the wires properly.
See Wiring connection. ( 13)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the [ terminal of the car battery.
5
Reset the unit. ( 3)
12
Installing the unit (in-dash mounting)
Hook on the top side
Orientate the trim
plate as illustrated
before fitting.
How to remove the unit
1
Detach the faceplate.
2
Fit the catch pin on the
extraction keys into the
holes on both sides of the
trim plate, then pull it out.
3 Insert the extraction keys
deeply into the slots on
each side, then follow the
arrows as shown on the
right.
Do the required wiring.
( 13)
Dashboard of
your car
Bend the appropriate tabs to hold
the mounting sleeve firmly in place.
Part list for
installation
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key