Table of Contents
Advertisement
TROUBLESHOOTING
Sympt om
Remedy
" DEVICE FULL"
The num ber of regist ered devices has reached it s lim it .
Ret ry aft er delet ing an unnecessary device. (
DEVICE DELETE)
" N/ A VOICE TAG"
Make sure t he sam e voice as t he regist ered voice t ag is
used.
" NOT SUPPORT"
The connect ed phone does not support Voice Recognit ion
feat ure or phonebook t ransfer.
" NO ENTRY" / " NO PAIR"
There is no regist ered device connect ed/ found via
Bluet oot h.
" ERROR"
Try t he operat ion again. If " ERROR" appears again, check if
t he device support s t he funct ion you have t ried.
" NO INFO" / " NO DATA"
Bluet oot h device cannot get t he cont act inform at ion.
" HF ERROR XX" /
Reset t he unit and t ry t he operat ion again. If t his does not
" BT ERROR"
solve t he problem , consult your nearest service cent er.
" SWITCHING NG"
The connect ed phones m ight not support phone sw it ching
feat ure.
(For
)
Mut ing upon t he recept ion of a phone call
Connect t he MUTE w ire t o your t elephone using a com m ercial t elephone accessory.
(
28)
When a call comes in, "CALL" appears. (The audio syst em pauses.)
To cont inue list ening t o t he audio syst em during a call, press
•
and t he audio syst em resum es.
When the call ends, "CALL" disappears. (The audio syst em resum es.)
26
ENGLISH
INSTALLATION/CONNECTION
Warning
The unit can only be used w ith a 12 V DC pow er supply, negative ground.
•
Disconnect the battery's negative term inal before w iring and m ounting.
•
16,
Do not connect Battery w ire (yellow ) and Ignition w ire (red) to the car chassis or Ground w ire
•
(black) to prevent a short circuit.
To prevent short circuit:
•
– Insulate unconnected w ires w ith vinyl tape.
– Be sure to ground this unit to the car's chassis again after installation.
– Secure the w ires w ith cable clam ps and w rap vinyl tape around the w ires that com e into
contact w ith m etal parts to protect the w ires.
Caution
For safety's sake, leave w iring and m ounting to professionals. Consult the car audio dealer.
•
Install this unit in the console of your vehicle. Do not touch the m etal parts of this unit during
•
and shortly after use of the unit. Metal parts such as the heat sink and enclosure becom e hot.
Do not connect the
•
them in parallel.
• Mount the unit at an angle of less than 30º.
If your vehicle w iring harness does not have the ignition term inal, connect Ignition w ire (red)
•
to the term inal on the vehicle's fuse box w hich provides 12 V DC pow er supply and is turned
on and off by the ignition key.
Keep all cables aw ay from heat dissipate m etal parts.
•
After the unit is installed, check w hether the brake lam ps, blinkers, w ipers, etc. on the car are
•
w orking properly.
If the fuse blow s, first m ake sure the w ires are not touching car's chassis, then replace the old
•
fuse w ith one that has the sam e rating.
. " CALL" disappears
[
w ires of speakers to the car chassis or Ground w ire (black), or connect
Hide quick links:
Advertisement
Table of Contents
