Sharp LC-32HT3U Service Manual page 38

LC-32HT3U/LC-37HT3U/LC-42HT3U
9. Even a single failure in the process will trigger the upgrade failure screen as shown below. The word "NG" changes to red for the item failed.
NOTE: In the event of a failure, repeat the upgrading process. If the process repeatedly fails, it is likely that the hardware is troubled.
10.Upon completion of the whole process, the upgrade success screen as shown below appears. You can check the new software version on this
screen. The version information appears after the upgrade is complete.
11.Shut off the AC power to the unit (unplug the AC cord), and remove the SD card for version upgrade.
12.Now the software version upgrade is complete.
NOTE: When you are done with the software version upgrade, start the set, go to the top page of the adjustment process screen and check the main
software version information.
< UPGRADE FAILURE >
MAIN EEPROM
0 % OK NG 100 %
SD-CARD
MONITOR
NG
NO DATA OK DETECT
OLD Version U0611093
U0611152
NEW Version
CFE-HT3U 1.00
Boot Version
< UPGRADE SUCCESS >
MAIN EEPROM
100 % 100 %
OK NG
SD-CARD
MONITOR
NO DATA OK NG DETECT
U0611093
OLD Version
U0611152
NEW Version
CFE-HT3U 1.00
Boot Version
3 – 3
BOISE_HT3U
OK NG
OK NG
BOISE_HT3U
OK NG
OK NG