Table of Contents
Advertisement
EG2–366
SERVICE SPECIFICATIONS
SERVICE DATA
Thermostat
Radiator cap
Radiator
On–vehicle
inspection
for hydraulic–
driven cooling
motor
Hydraulic
motor
ECT sensor
TORQUE SPECIFICATIONS
RH Drain plug x Cylinder block
LH Drain plug x Cylinder block
Water pump x Cylinder block
No.3 timing belt cover x Cylinder head
No.2 idler pulley x Cylinder heads
Camshaft pulley x Camshaft
Camshaft pulley x Camshaft (For use with SST)
Water inlet x Water inlet housing
Water inlet pipe x LH cylinder head
Hydraulic motor pressure hose x Water inlet
Radiator oil cooler x Radiator lower tank
Radiator pipe x Radiator lower tank
Pressure hose x Hydraulic motor
Radiator support bolt
Hydraulic motor housing x Motor cover
Hydraulic motor x Fan shroud
Cooling fen x Hydraulic motor
Hydraulic cooling fan x Radiator
Oil cooler (for hydraulic cooling fan)
x RadiAtor lower support
1MZ–FE ENGINE
Part tightened
–
COOLING SYSTEM
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the 1 MZ–FE and is the answer not in the manual?
Questions and answers
Hacia donde apunta el pistón y como se colocan los anillos en un motor Toyota 3.0 1mzfe?
The piston in a Toyota 3.0 1MZ-FE engine should be oriented with the front marks of the piston and connecting rod aligned. The piston pin should be pushed in with the thumb, and a new snap ring should be installed on the other end, ensuring the snap ring’s end gap is not aligned with the pin hole cutout portion of the piston.
For ring installation:
1. Install the oil ring expander and two side rails by hand.
2. Use a piston ring expander to install the two compression rings with the code mark facing upward. The code marks are:
- No.1: 1R or T
- No.2: 2R or 2T
3. Position the piston rings so that the ring ends are not aligned.
This answer is automatically generated
power steering high pressure line repair instructions