Troubleshooting; Error Codes - Lamona LAM1763 User's Installation Manual

05 - Troubleshooting

If you encounter a problem, it is often something minor, please read some of the suggested tips below.
The hob produces a smell the first few times
it is used
Pans make a noise during cooking!!
The hob makes a slight clicking sound
The fan keeps working for a few minutes after the hob has been
turned off
The hob won't work. The indicators don't come on
The hob has turned itself off
Repairs

Error codes

Appliance Errors
ER03 and
permanent tone
E2
1. Pot/pan not suitable, example
because of temperature at bottom
E3
E/H
Fault Description
Continuous button actuation;
control switches off after 10 s
Over temperature
Loss of magnetic properties
of pot.
2. Power of cooking zones
permanently exceeded
Invariable resistor fault
This is normal - Heat a pan full of water on each zone for half an hour.
This is caused by vibration due to the passage of energy from the hob
to the pan. On a high setting this is quite normal for certain types of
saucepan. It will not damage the hob.
This is Normal - This is caused by the distribution of power between
two heating zones on the same side of the hob.
This is Normal - To cool down the electronics.
The electricity supply is not reaching the appliance (faulty supply or
connection); Check the fuses and the cut-out switch.
Refer to Troubleshooting chart and if problems persist call, the
customer service hot-line for further assistance.
Check that the main on/off switch has not been touched or covered
accidentally, remove any objects on the hob and try turning it back
on again.
Repairs are to be carried out by trained service technicians.
Clean the user interface.
Allow system to cool
1. This error is reset after 30 s; the cooking zones can
be used again. The pot/pan must be removed if the fault
keeps reoccurring.
2. The power unit must be replaced if the error
continues to be displayed even when no pot/pan is
present on the cooking zone.
Induction module must be cool
User manual LAM1763
Action
Troubleshooting
_ 15