Automatic Technology GDO-10V3L2 Toro User Manual page 26

Appendix
C - Control Board Adjustments
Menu 6.12 FIRE Input Configuration
Fire input can be configuration as OPN ,CLS (available only if Safety Beams are installed) or PED function. Activated by
FIRE input terminal with N/O or N/C (if selected) switch.
i. When Fire Input Is Configured As CLS :
Holding the input active will prevent door from opening.
ii. When Fire Input Is Configured As PED:
but prevent vehicle access. The position the door is driven to is automatically set to halfway during setting of the travel
limits, but can be adjusted to suit.
iii. When Fire Input Is Configured As OPN :
the door from closing.
6.13 Remote Code
The controller supports the Remote Code Set feature. This parameter can be used to disable the feature for security or transmitter
management reasons.
6.14 Activity Reports
This parameter enables activity report outputs. Contact Automatic Technology for more details.
6.15 Activity Report ID
This parameter sets the ID of the controller that is sent with the activity report. Contact Automatic Technology for more
details.
6.16 Vacation Mode
Vacation Mode can be turned on or off using this parameter.
6.17 Standby Battery Enable/Disable
The controller can be instructed to turn off the Battery Backup facilities so that the control board can be shut down without having
to disconnect the Battery Backup system.
6.18 Password Protection
The password feature enables all parameters and configuration settings to be protected unless a password is entered.
When this feature is turned on, the user is requested to enter the desired password to be used. The password protection
feature has a time-out that expires after 60 seconds of inactivity. Alternatively, the user may log out manually by pressing
exit when the main screen is displayed.
6.19 Transmitter Grouping
The transmitter store number display format can be changed to show a grouped format. When grouping is selected,
instead of displaying the store location as a number between 1 and 511, it will display as ##$ where ## is the group number
and $ is a character a,b,c,d,e,f,g or h which indicates the group member.
6.20 Fault, Auto Reset
When selected, the controller will reset any fault automatically.
6.21 LED Low Power Mode
When LED low power mode is selected, the controller will turn the LED power off to save the power.
6.22 Console OSC Buttons
Console can be locked out by selecting console OSC buttons OFF.
6.23 AUX Output Operation
AUX output can be selected to be driven by:
i. Light Drive: Although the GDO10V3L2 drive unit has a light relay output, a light relay module can be connected on the console
between V+ and AUX OUT terminal which will turn the courtesy light on and off.
ii. Clock/Transmitter: By selecting this option, AUX output can be triggered by programming the clock timer or by the transmitter.
iii. Open Status: Selecting this option will cause the AUX output to stay active as long as the door stays open.
iv. Close Status: Selecting this option will cause the AUX output to stay active as long as the door stays closed.
6.24 Safety Beam Failure Emergency Close Mode (SBFEC)
When a safety beam prevents movement due to any reason other than a 'real' obstruction, the user can secure their
property by pressing and holding a button on the remote control or OSC on the console. The button must be held active
for more than five seconds to activate this mode and hold the button for the entire duration of close cycle.
26 GDO-10V3L2 Toro
Activating the fire input will cause the door to close only if Safety Beams are installed.
The activation of fire input will open the door partially to allow pedestrian access
Activating the fire input will cause the door to open. Holding the input will prevent
Owner Installation Instructions
™