Makita LS1013 Instruction Manual page 23

Crown molding stoppers (optional accessories) allow easier cuts of crown molding with-
out tilting the saw blade. Install
them
on
the turn
base as shown in the figure
below.
Position in Fig ( C )
0
0
0
@
For inside corner
For outside corner
At right 45" miter angle
Miter angle Finished piece
Right 45"
Left 45O
Right 45'
Save the right side of blade
Save the left side of blade
Save the right side of blade
Save the left side of blade
Crown molding Crown molding
stopper L stopper R
I I
Turn base
At left 45" miter angle
Crown molding
Crown molding
stopper L stopper R
1 -
Crown molding
Crown molding stopper
Screw
I
Fig. (D)
Position crown molding with its WALL CONTACT EDGE against the guide fence and its
CEILING CONTACT EDGE against the crown molding stoppers as shown in Fig. (D).
Adjust the crown molding stoppers according to the size
of
the crown molding. Tighten
the screws to secure the crown molding stoppers. Refer to the table (C) for the miter
angle. Use the sub-fence R to secure the crown molding more firmly.
23