Makita LS1013 Instruction Manual page 14

CAUTl
ON :
The workpiece must be secured firmly against the turn base and guide fence with the vise
during all operations.
CAUTl
ON
:
When cutting long workpieces, use sup-
If some part contacts the vise, re-position the vise arm. Press the workpiece flat against
the guide fence and the turn base. Position the workpiece at the desired cutting position
and secure it firmly by tightening the clamp screw of the vise
S U D D O ~ ~ Turn base
ports that are as high as the top surface
level of the turn base.
Horizontal vise (optional accessory)
The horizontal vise can be installed in two
positions on either the left or right side of
the base. When performing 15" or greater
miter cuts, install the horizontal vise on the
side opposite the direction in which the
turn table is to be turned. By flipping the
vise nut to the left, the vise is released, and
rapidly moves in a and out. To grip work-
pieces, push the vise knob forward until the
vise plate contacts the workpiece and flip
the vise nut to the right. Then turn the vise
knob clockwise to secure the workpiece.
The maximum width of workpieces which
can be secured by the horizontal vise is 200 m m (7-7/8").
When installing the horizontal vise on the right side of the base, also use the sub-fence R
to secure the workpiece more firmly. Refer to the "Sub-fence R
"
described on previous
page for installing the sub -fence R.
CAUTION:
Always set the vise nut to the right fully when securing the workpiece. Failure to do so
may result in insufficient securing of the workpiece. This could cause the workpiece to be
thrown, cause damage to the blade
or
cause the dangerous loss of control of the tool.
14