Makita LS1013 Instruction Manual page 20

In the case of right bevel cut
~
~ ~ ~ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Bevel angle
Position
in Fig ( C ) 52/38' type 45' type
0
Q
For inside corner
-
Right 33 9" Right 30"
m
Table (A)
Miter angle
52/38' type 45' type
Right 31 6"
Right 35 3'
Left 31
6 O
Left 35 3 O
Right 31.6' Right 35.3'
position
in Fiq ( C )
I h l
Wall contact edqe should be
I
Molding edge against guide fence Finished piece
For inside corner
Q
~
c 3
Finished piece will be on the
Right side of blade
against guide fence
Ceiling contact edge should be
against guide fence
(Example)
In the case of cutting 52/38' type crown molding for position
0
in Fig. (CI:
*Tilt and secure bevel angle setting to
33.9"
RIGHT.
*Adjust and secure miter angle setting to
31.6"
RIGHT.
*Lay crown molding with its broad back surface down on the turn base with its
WALL
CONTACT EDGE against the guide fence
on
the saw.
*The finished piece
to
be used will always be
on
the RIGHT side of the blade after the
cut has been made.
For outside corner
-
Finished piece will be on the
.
Left side of blade
~
Wall contact edge should be
against guide fence