Drying (Dehumidifying); Heating - Mitsubishi Electric 2.5KKC Operation Manual

CENTRALLY CONTROLLED
B
ON OFF
CHECK
CLOCK
STAND BY ˚C
DEFROST
CLOCK
2
3
TEMP. TIMER SET
REMOTE CONTROLLER
PAR-JH240KA
5
B
CENTRALLY CONTROLLED
ON OFF
CHECK
CLOCK
C
˚C
STAND BY
DEFROST
D
CLOCK
2
3
TEMP. TIMER SET
REMOTE CONTROLLER
PAR-JH240KA
6
ON/OFF –
1Hr.
FILTER
˚C
CHECK MODE
TEST RUN
NOT AVAILABLE
ON OFF
FILTER
CHECK
TEST RUN
4
ON/OFF –
1Hr.
FILTER
˚C
CHECK MODE
TEST RUN
NOT AVAILABLE
ON OFF
FILTER
CHECK
TEST RUN
4 5
4. Operation
E

4.4. Drying (dehumidifying)

1 If the unit is off, press the ON/OFF button to turn it on.
A The ON indicator should light up.
2 Press the operation mode
drying mode .
B
should be displayed.
3 If necessary, press
See page 10 for details.
A
4 If necessary, press
air is blowing.
See page 14 for details.
1
5 If necessary, press
See page 11 for details.
Note:
• When the room temperature is lower than 18
cannot be set.
• This reduces the operation level of the indoor fan.
See page 13 for details.
• There may be times when the airflow volume does not match the
display on the remote control unit.

4.5. Heating

1 If the unit is off, press the ON/OFF button to turn it on
A The ON indicator should light up.
2 Press the operation mode
heating mode .
B
should be displayed.
3 If necessary, press
See page 10 for details.
A
4 If necessary, press
See page 13 for details.
1
5 If necessary, press
air is blowing.
See page 14 for details.
6 If necessary, press
See page 11 for details.
The fan speed may differ from the set speed at the start of the heating
mode, during the defrosting mode, or after shutdown of the heating mode.
C "STAND BY" is displayed from the moment heating begins until warm air is
blown out.
D "DEFROST" is displayed during defrosting.
button and select the
button to set the desired temperature.
TEMP.
to specify the vertical angle at which the
button to set the timer setting.
°
C, the drying mode
button and select the
button to set the desired temperature.
TEMP.
button to select a desired rate.
to specify the vertical angle at which the
button to set the timer.
9