CENTRALLY CONTROLLED
ON OFF
CHECK
CLOCK
˚C
STAND BY
DEFROST
CLOCK
TEMP.
TIMER SET
REMOTE CONTROLLER
PAR-JH240KA
CENTRALLY CONTROLLED
B
ON OFF
CHECK
CLOCK
˚C
STAND BY
DEFROST
CLOCK
TEMP.
TIMER SET
REMOTE CONTROLLER
PAR-JH240KA
2
6
3
8
ON/OFF –
1Hr.
FILTER
˚C
CHECK MODE
TEST RUN
NOT AVAILABLE
ON OFF
FILTER
CHECK
TEST RUN
ON/OFF –
1Hr.
FILTER
˚C
CHECK MODE
TEST RUN
NOT AVAILABLE
ON OFF
FILTER
CHECK
TEST RUN
4
5
4. Operation
E
4.2. Switching the unit on/off
s s s s s Before pressing the ON/OFF button:
•
Check to see if the power supply is on.
•
The power supply should not be turned off while the air conditioner is
in use. This can cause the unit to break down.
1 Press the ON/OFF button.
A The ON indicator should light up.
A
Note:
1
•
Even if you press the ON/OFF button immediately after shutting
down the operation in progress, the air conditioner will not start
for about three minutes. This is to prevent the internal compo-
nents from being damaged.
•
If the operation stops due to a power failure, the unit will not au-
tomatically restart until the power has been restored. Press the
ON/OFF button to restart.
4.3. Cooling
1 If the unit is off, press the ON/OFF button to turn it on.
A The ON indicator should light up.
2 Press the operation mode
cooling mode
B
should be displayed.
3 If necessary, press
See page 10 for details.
A
4 If necessary, press
See page 13 for details.
1
5 If necessary, press
air is blowing.
See page 14 for details.
6 If necessary, press
See page 11 for details.
button and select the
.
button to set the desired temperature.
TEMP.
button to select a desired rate.
to specify the vertical angle at which the
button to set the timer.