Troubleshooting - Spitwater G120 Operating Instructions Manual

STOrAGE
Store the appliance in premises protected against
freezing conditions.
If freeze protection is not guaranteed, suction a glycol
based anti-freeze into the pump, as for cars
- Immerse the water pipe into the container of anti-
freeze
- Immerse the gun without the sprayer nozzle into the
same container
- Insert the appliance with open gun
- Activate the gun until an even jet is obtained.
Store the rest of the anti-freeze in a closed container.
11

TrOuBlESHOOTING

Before starting any work the machine, unplug the power cable, turn off the water supply and actuate the spray
gun until the pressure has been relieved completely.
Fault
Pressure fluctuates or drops
Motor hums when switched on,
but does not start
Motor will not start when
switched on
Motor stops
The detergent fails to come out
Jet is ineffective, unsteady
Treatment of waste from electric/electronic
equipment
Dispose of the product in accordance with current
regulations concerning differentiated waste disposal
in dedicated waste disposal areas. Do not treat as
simple urban waste.
For any information please contact the manufacturer
at the address specified in the user manual.
Cause
Lack of water
Water filter clogged
Mains voltage too low
Spray gun not actuted
Cross-section of extension lead
too small
Power supply not OK
Mains fuse tripped
Motor protection switch tripped
due to motor overheating
Clogged injector
Clean the nozzle of the foam
launch
Selector sleeve for type of jet
wrongly set
13
The product complies with the requirements
of the new directives introduced for the envi-
ronmental safeguard and must be disposed of
appropriately at the end of its life cycle.
Remedy
Turn on water supply
Clean the water filter on the
pump supply tube.
Check electrical connection
On switching on the machine,
engage the gun
Use correctly dimensioned exten-
sion lead, see "Connect machine
to power supply"
Check plug, cable and switch
Resert mains fuse
Check that power supply matches
appliance voltage, wait 3 minutes,
then switch machine on again
Clean the detergent spray nozzle
element
Clean the high pressure nozzle.
Adjust selector sleeve