Assembly And Adjustments - DeWalt DCL508 Original Instructions Manual

EN G LI S H
Your D WALT charger is double insulated in accordance with
E
EN 60335; therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by a specially
prepared cord available through the D
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be made to the earth
terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless absolutely necessary.
Use an approved extension cable suitable for the power input of your
charger (see Technical Data). The minimum conductor size is 1 mm
the maximum length is 30 m.
When using a cable reel, always unwind the cable completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: Use only D
Inserting and Removing the Battery Pack
from the Tool (fi g. 3)
NOTE: Make sure your battery pack (b) is fully charged.
58
WALT service organisation.
E
WALT battery packs and chargers.
E
;
2