Table of Contents
Advertisement
Quick Links
AGA Wren Non Boiler Stove
(Smoke Exempt)
This appliance is hot while in operation and retains its heat for a long period of time after use.
Children, aged or infirm persons should be supervised at all times and should not be allowed
to touch the hot working surfaces while in use or until the appliance has thoroughly cooled.
When using the stove in situations where children, aged and/or infirm persons are
present a fireguard must be used to prevent accidental contact with the stove. The fireguard
should be manufactured in accordance with BS 8423:2002.
INSTALLATION AND OPERATING INSTRUCTIONS
Advertisement
Table of Contents
Related Manuals for AGA Wren NB
Summary of Contents for AGA Wren NB
- Page 1 AGA Wren Non Boiler Stove (Smoke Exempt) This appliance is hot while in operation and retains its heat for a long period of time after use. Children, aged or infirm persons should be supervised at all times and should not be allowed to touch the hot working surfaces while in use or until the appliance has thoroughly cooled.
-
Page 2: Table Of Contents
TABLE OF CONTENTS PAGE NO. Installation & Operating Instructions ........General . -
Page 3: Installation & Operating Instructions
Further information on the requirements of the Clean Work Act are met. Air Act can be found here : Any alteration that is not approved by AGA, could http://smokecontrol.defra.gov.uk/ invalidate the approval of the appliance, operation of the warranty and could also affect your statutory Your local authority is responsible for implementing rights. -
Page 4: Pre-Installation
TOP FLUE EXIT PRE-INSTALLATION Before using the stove for the first time all remaining For the top outlet configuration, remove the blank- stickers must be removed, all accessories must be ing plate from the hob, remove the flue spigot from removed from the ashpan, check if any items have the back plate and fix it to the hob. -
Page 5: Ventilation & Combustion Air Requirements
Fig 2 If there is another appliance using air fitted in the same or adjacent room, it will be necessary to provide an additional air supply. All materials used in the manufacture of air vents should be such that the vent is dimensionally stable, corrosion resistant, and no provision for closure. -
Page 6: Commissioning & Handover
FLOOR PROTECTION Note:- If there is any work that is being carried out that would effect the air quality supplied to the stove The product must be placed on a non combustible such as sanding a floor or glueing linoleum etc. the hearth in accordance with UK Building Regulation stove must be out of operation. -
Page 7: Stove Dimensions
STOVE DIMENSIONS Fig. 4 Note: Dimensions stated are in milimeters and may be subject to a slight +/- variation. TECHNICAL DATA FUEL WOOD ANCIT Nominal Output - Room 4.8 kW 4.9 kW Typical refuelling intervals to 1 Hour 1 Hour obtain nominal outputs Fuel Gas Mass Flow 4.4 g/s... -
Page 8: Air Controls
AIR CONTROLS Wood should be kept under cover and kept as dry as possible prior to use. Wood logs of diameter less The stove has two independent air controls. than 80mm and no more than 310mm long are recommended. 1. The primary air control or spin valve. Rotate the spin valve clockwise to close and anticlock- Do not use liquid fuels or any fuels with a Petro-coke wise to open. -
Page 9: Operation With Door Left Open
Operation with door left open WARNING - NEVER DISPOSE OF ASH WHEN Operation with the door open can cause excess STOVE IS LIGHTING. smoke. The appliance must not be operated with the appliance door left open except as directed in IMPORTANT - DAMAGE CAN OCCUR TO THE the instructions. -
Page 10: Important Notes
Use only the best results from your stove. replacement parts recommended by AGA. Using unauthorised parts will invalidate 1. We would like if you could take some time to... -
Page 11: Lighting
3. A practical evacuation plan. LIGHTING 4. A plan to deal with a chimney fire as follows: Before lighting the stove check with the installer that the installation work and commissioning Notify the fire department. checks described in the installation instructions Prepare occupants for immediate evacua- have been carried out correctly and that the tion. -
Page 12: Enamel Cleaning
and ensure it it resting on the protrusion in front and GLASS that the positional stops are interlocked with the mid- 1. How to clean: dle baffle. See Fig.9 The glass will clean itself when there is sufficient Fig.9 heat generated by burning fuel. If a build-up of creosote occurs on the glass it may be due to draft conditions, poor quality fuel or very slow burning for a long time. -
Page 13: Exploded View
EXPLODED VIEW BASE - AF0501 22. SPIGOT - I125 - 0502 23. DOOR HINGE - CA1602 FRONT - 0503 24. AIR WASH SHUTTER - CA1113-05SE BACK - 0504 25. RIDDLING ROD - CA1401-SM05 LH SIDE - AF0505 26. PULL ROD KNOB - CA010402 RH SIDE - AF0506... -
Page 14: Trouble Shooting
TROUBLE SHOOTING SYMPTOM POSSIBLE CAUSES REMEDY Stove Difficult To Light Air controls set incorrectly Air controls must be set to maximum settings on initial light-up Moisture content of fuel too high Ensure fuel is sufficiently dry Fire Burns Too Quickly Air controls set incorrectly Adjust Air controls Rope seals perished/worn... - Page 15 SYMPTOM POSSIBLE CAUSES REMEDY Creosote/Tar Build-up in Firebox Insufficient flue draught Seek professional chimney advice and on Flue Pathways Moisture content of fuel too high Ensure fuel is sufficiently dry Fuel excessively dirty Use correct fuel Air controls set to minimum settings Constant low burning can produce excessive soot Smells From Stove/Installation...
- Page 16 AGA, Station Road, Ketley, Telford, Shropshire, TF1 5AQ,...
Need help?
Do you have a question about the Wren NB and is the answer not in the manual?
Questions and answers