Table of Contents
Advertisement
Quick Links
Ludlow Non-Boiler
(Multi-Fuel)
This appliance is hot while in operation and retains its heat for a long period of time after use.
Children, aged or infirm persons should be supervised at all times and should not be allowed
to touch the hot working surfaces while in use or until the appliance has thoroughly cooled.
When using the stove in situations where children, aged and/or infirm persons are
present a fireguard must be used to prevent accidental contact with the stove. The fireguard
should be manufactured in accordance with BS 8423:2002.
WHEN READING THESE INSTRUCTIONS REFER TO THE SECTIONS ON LIGHTING THE FIRE
& REFUELLING
INSTALLATION AND OPERATING INSTRUCTIONS
Advertisement
Table of Contents
Related Manuals for AGA Ludlow Non-Boiler
Summary of Contents for AGA Ludlow Non-Boiler
- Page 1 Ludlow Non-Boiler (Multi-Fuel) This appliance is hot while in operation and retains its heat for a long period of time after use. Children, aged or infirm persons should be supervised at all times and should not be allowed to touch the hot working surfaces while in use or until the appliance has thoroughly cooled.
-
Page 2: Table Of Contents
TABLE OF CONTENTS PAGE NO. General ............. . Pre-Installation Assembly. -
Page 3: General
LUDLOW (MULTI-FUEL) NON-BOILER STOVE INSTALLATION & OPERATING INSTRUCTIONS IMPORTANT WARNING: This stove must not be NOTE: Please note that it is a legal requirement installed into a chimney that serves any other under England & Wales Building Regulations that heating appliance. There must not be an extrac- the installation of the stove is either carried out tor fan fitted in the same room as the stove as under Local Authority Building Control approval or... -
Page 4: Chimney
relined using an approved lining system. The stove 2300 Fig.1 must be connected to a chimney with a minimum continuous draught of 12 Pascal’s (.05” WG). Poor draught conditions will result in poor performance. All register plates, restrictor plates, damper etc., which could obstruct the flue at a future date should be removed before connecting this appliance. -
Page 5: Rear Flue Exit
Fig.4 For the top flue outlet configuration, remove the blanking plate from the hob, remove the flue spigot from the back plate and fix it to the hob. Fix the out- let blanking plate to back plate (see Fig.2). Push the flue outlet connector pipe (not supplied) into the flue spigot and cement into place using approved fire cement, ensuring that no fire cement is blocking the... -
Page 6: Permanent Air Vent
pass through normally occuppied areas of the room. Further guidance on the installation of the An air vent outside the building should not be locat- carbon monoxide alarm is available in BS EN ed less than the dimensions specified within the 50292: 2002 and from the alarm manufacturer’s Building Regulations and B.S. -
Page 7: Clearance To Combustibles
CLEARANCE TO COMBUSTIBLES It is recommended that this appliance is sited next to and on a non-combustible surface. A minimum all round clearance of 100mm will allow air circulation and not impede the performance of the stove. If it is necessary to site the stove near to a combustible surface a minimum clearance of 700mm to side walls and rear walls must be maintained. -
Page 8: Stove Dimensions
STOVE DIMENSIONS Fig.5 HOW TO OPERATE YOUR STOVE LIGHTING THE FIRE Outputs Nominal heat output Use small pieces of dry kindling and light using Wood logs 7.1 kW a chemical firelighter or paper. Add extra kin- Manufactured smokeless fuel (MSF) 6.6 kW dling in small amounts and wait for the flame to establish before adding more kindling. -
Page 9: Operating
OPERATING SECONDARY AIR CONTROL Check that all controls and catches are operating Open the secondary air control situated over the correctly and ensure that all flue connections are door fully by sliding to the right. The marks situated thoroughly sealed. Set all air controls to fully open. nearby are indicators for the amount of opening ranging from a short bar - less air to a long bar - Primary Air Control - spin wheel (Fig. -
Page 10: Tertiary Air Control
TERTIARY AIR CONTROL Fig.9 When burning wood pull out fully the control knob. This air control is a push pull operation, pull for fully open and push for fully closed. The control can be gradually moved between fully open and fully closed for the desired setting. -
Page 11: Maintenance
MAINTENANCE FIRE SAFETY To provide reasonable fire safety the following CREOSOTE: Formation and Need for Removal should be given serious consideration: When some fuels are burned slowly, they produce tar and other organic vapours, which combine with 1. The installation of smoke detectors. expelled moisture to form creosote. -
Page 12: Lighting
13. This appliance should be regularly maintained GLASS by a competent service engineer. Use only replacement parts recommended by AGA Using 1. How to clean: unauthorised parts will invalidate your guaran The glass will clean itself when there is sufficient tee and may cause damage or injury. -
Page 13: Exploded View
31. RIDDLING ROD 32. SPIGOT 14. DAMPER PULL ROD 15. DOOR HANDLE AXLE 33. SPINVALVE 34. SPRING HANDLE ASSY 16. FIRE BED 35. TOP BAFFLE 17. FIRE DOOR 18. FIRE FENCE AGA, Station Road, Ketley, Telford, Shropshire, TF1 5AQ, N00613AXX 131007...
Need help?
Do you have a question about the Ludlow Non-Boiler and is the answer not in the manual?
Questions and answers