Troubleshooting And Care Instructions - Torqeedo Hobie eVolve Owner's Manual

Troubleshooting and Care Instructions

Fault Codes
Display Cause
E02 Engine overheating
E03 Motor tilted during operation Motor can be used again after tilting it down and
E04 Motor put into operation
while tilted
E05 Motor/propeller blocked
E06 Voltage in motor too low
E07 Motor Overcurrent
E08 Circuit board overheating
E21 Remote Throttle calibration
defective
E22 Magnetic sensor defective
E23 Value range false
E30 Motor communication error
E32 Remote throttle control
communication error
E33 General communication
error
E41,42 Incorrect charging voltage
E43 Battery empty
E45 Battery overcurrent
What to do
Motor can be used again after a short wait (about
10 minutes) Contact Torqeedo Service.
pressing on/off.
Motor can be restarted from the stop position after
being tilted down.
Loosen blockage and turn propeller one revolution
by hand.
Low battery charging status. Motor can be used
again slowly from the stop position.
Continue at low output. Contact Torqeedo
Service.
Motor can be used again after a short wait (about
10 minutes). Contact Torqeedo Service.
Re-Calibrate Throttle by:
1. Press the middle button for 10 seconds. The
display will show "cal up".
2. Press remote throttle control to full gas then
press the middle button.
3. The display shows "cal stp". Return remote
throttle control to central position then press the
middle button.
4. The display shows "cal dn". Press the remote
throttle control to full reverse position then press
middle button.
Re-calibrate (refer to E21)
Re-calibrate (refer to E21)
1. Check the motor cable's plug-in connection.
2. Check the motor cable for damage.
3. Check the fuse on the underside of the battery.
If applicable replace the fuse. If the fuse is
replaced, the information display will not show
correct data until the battery is fully charged again.
Check the remote throttle control cable's plug-in
connection. Check the cable.
Check the plug-in connections and cables. Switch
the motor off and on again.
Check whether the power supply unit used has
an output voltage between 10 V and 20V. If
necessary contact Torqeedo Service.
Charge battery. Motor can be used again slowly
from the stop position if necessary.
Switch motor off and on again. The information
display will not show correct data after this error
occurred. The battery needs to be fully charged to
reset the information system.
24