Panasonic DBS 824 Manual page 433

Hide thumbs Also See for DBS 824:

Table of Contents

LCR Trunk Groups

Software Version CPC-S and CPC-M, Version 1 0 and higher

Address FF8 W (TrunkGrp)# (Position)# (Trunk)#

Use this program to set up LCR trunk groups Set up LCR trunk groups

before setting up Time Priority Route Tables

LCR uses 4 trunk groups, each consisting of 4 trunks The trunks in each

group are prioritized according to their cost-effectiveness, so that LCR tries

the highest priority trunk in the group first, then the next highest, etc

Different LCR trunk groups are used at different times of the day The time

of day during which an LCR trunk group is used is determined by the Time

Priority Route Tables (see program address FF8 5#)

LCR selects trunks from trunk groups in priority order, the most cost-

effective trunks receive the highest priority, so that LCR tries to use them

first The priority of a trunk is determined by its position in the trunk group

A trunk in position 1 has the highest priority in the group A trunk in position

4 has the lowest priority in the group LCR trunk selection is illustrated in the

following table

LCR trunk selection

LCR is activated

The first trunk is busy

The second trunk is busy

The third trunk is busy

The fourth trunk is busy

issued 3/l 195

DBS 824-l O-400

LCR Trunk Groups

LCR tries the trunk in position

LCR tries the trunk in position 1

of the next trunk group, as

determined by the Time Priority

Route Table (program address

Chapters

Table of Contents