NEC EcoPowerGateway N8142-36F User Manual page 85

Security
Select "Set Supervisor Password" or "Set User Password" and press Enter to display the pop-up
screen. Note that User password setup is not available before Supervisor password setup.
Set a password on the pop-up screen. Enter a password of up to eight alphanumeric characters and
symbols from the keyboard.
IMPORTANT:
User password setup is not available before Supervisor password
setup.
If you have forgotten your password, ask your service
representative.
Option
User Password Is
Supervisor
Password Is
Set User
Password
Set Supervisor
Password
Password on boot
Fixed disk boot
sector
Power Switch
Inhibit
Parameter
[Clear]
Set
[Clear]
Set
Up to eight
*1
alphanumerics
Up to eight
*1
alphanumerics
[Disabled]
Enabled
[Normal]
Write Protect
[Disabled]
Enabled
Configuring Your EcoPowerGateway 4-15
Description
Indicates the user password setting
status (view only).
Indicates the supervisor password
setting status (view only).
Press Enter to display the user
password entry screen. With a user
password, accessible SETUP menus
are restricted.
This option is available only when you
log into the SETUP utility with the
password "Supervisor".
Press Enter to display the supervisor
password entry screen. With the
supervisor password, all SETUP
menus are available for access.
This option is available only when you
log into the SETUP utility with the
password "Supervisor".
Specify whether to request a user
password entry at boot-up. User
password must be set beforehand.
If the supervisor password is set and
this option is disabled, BIOS
determines that a user is booting.
Specify whether to permit writing into
boot sector of the SATA hard disk drive
or not.
Specify whether the Maintenance
switch is enabled or disabled. If
Enabled, the Maintenance switch
cannot be used to power off the
maintenance card. (The forced
shutdown, by pressing the POWER
switch for 4 seconds or longer, is
available.)
Your Setting