Cannot See The Controller - Toshiba GL-1010 Administrator's Manual

Cannot See the Controller

Problem Description
After installing and configuring the controller, you cannot see it on the
network. This could be the result of controller problems, but is more likely
to be caused by network configuration errors.
The following checklist helps you identify the source of the error and
directs you to where you can find more information about resolving it. If
the problem persists after you have followed all of the steps, contact your
Toshiba authorized dealer for support.
Troubleshooting Checklist
Possible Cause
Controller is
initializing and is not
online yet
Controller is down
328
Cannot Find the Controller
Check
1 Did a startup page print out?
If not, wait until the controller
comes online. Examine the
protocol settings that print
out on the startup page. Are
they correct?
2 Are any error messages,
such as Starting
Controller. Please
Wait. displayed on the
copier control panel?
For Instructions,
Yes No
Modifying Protocol
Next
Settings Locally
Step
page 26.
Starting
Next
Controller,
Step
Please Wait or
Shut-down in
Progress, Please
Wait Message
Appears
page 312.
GL-10x0 Administrator's Guide
Go To...
on
on