Rps; Rps Connection Methods - Bosch ICP-EZM2 System Reference Manual

Easy Series Control Panel
Options
House Phone
Outside Phones
Installer Quick Connect
Table 4.1: Phone System Access Options
Notice!
For an overview of the Installer Phone Menu and User Phone Menu, refer to Phone Menus,
page 21.
For detailed Phone Menu programming options, refer to Programming, page 43.
4.2

RPS

RPS (Remote Programming Software) is a Windows-based account management and control
panel programming utility designed to remotely set up and program specific control panels.
You can use RPS to program the control panel from a laptop or PC that is on-site or off-site
from the control panel.
For complete installation and operation instructions, refer to the RPS Installation and Operation
Guide (P/N: 4998141259) that is available on the RPS CD-ROM.
Notice!
Once you configure a control panel using RPS, you can copy the programming from the
control panel to a programming key for use on another control panel, or for backup. Refer to
Programming Keys, page 41.
4.2.1

RPS Connection Methods

Connect to the Easy Series control panel to make changes interactively.
To connect RPS to the control panel:
1.
Bosch Security Systems, Inc.
Steps
– Press [#][#][#].
– Listen for the voice prompt to enter a passcode.
– Enter the installer passcode to access the installer menu, or a user
passcode to access the user menu.
– Call the premises phone number.
– After the call is answered by a person or by a telephone answering device,
press [*][*][*] to disconnect the answering party and access the system.
– Listen for the voice prompt to enter a passcode.
If the phone is not answered by a person or telephone answering device,
the system answers after a programmed number of rings. Refer to Expert
Programming Item Number 222 listed in on Route Destination Items.
– Enter the installer passcode to access the installer menu, or a user
passcode to access the user menu.
Select this option if a phone line is not available, or a local connection is
required. The system must be off to use this option.
– Connect a phone set to the test posts or to the phone terminals.
– Press and hold the System Test button for approximately 15 sec.
– Listen for the voice prompt to enter a passcode.
– Enter the installer passcode to access the Installer Menu, or a user
passcode to access the User Menu.
Open the control panel account by double-clicking the account, or select the account and
click Open.
System Reference Guide
Programming Access Options | en
2014.09 | 01 | F.01U.306.221
39