Loading Motor Replacement - Sony HDV HVR-1500 Service Manual

6-16. Loading Motor Replacement

Outline
Replacement
Disconnecting the connector
Replacing the loading motor assembly
Reconnecting the connector
Preparation
1. Set the unit to the unthreading end status.
2. Power off the unit.
3. Remove the top panel. (Refer to Section 2-7-1.)
4. Remove the cassette compartment. (Refer to Section 2-8.)
Tools
. Torque screwdriver's bit (for M1.4) :
. Torque screwdriver (for 3 kgf.cm) :
. Tweezers
Replacement
1. Disconnecting the connector
Disconnect the harness from the connector
(CN10) on the DR-428BG board with tweezers.
2. Replacing the loading motor assembly
(1) Remove the two precision screws to remove
the loading motor assembly.
(2) Align a positioning hole in a new loading
motor with the positioning pin on the MD
chassis and engage the motor gear with the
FG gear.
(3) Fix the loading motor assembly with the two
precision screws.
Tightening Torque : 0.1 N.m {1 kgf.cm}
3. Reconnecting the connector
Reconnect the harness to the connector (CN10)
on the DR-428BG board with tweezers.
6-48
J-6325-110-A
J-6325-400-A
Harness
CN10
DR-428BG board
Motor gear
FG gear assembly
Precision screw
P1.4 x 3.5
Precision screw
P1.4 x 3.5
Loading motor
assembly
Pin
HVR-1500