Installation Setup And Adjustment; Front Panel Setting; System Adjustment After Installation - Sony HDV HVR-1500 Service Manual

1-7. Installation Setup and Adjustment

1-7-1. Front Panel Setting

Front panel
1. i.LINK INPUT SELECT button setting
i.LINK : HDV: Video and audio signals in HDV
format
*
i.LINK : DV : Video and audio signals in DV
format
*
i.LINK : DVCAM : Video and audio signals in
DVCAM format
*
: The display follows the recording format setting in
the REC FORMAT menu item. (Refer to the
operating instructions for details)
2. VIDEO INPUT SELECT button setting
COMPOSITE: Composite video signal
(When HVBK-1505 is attached)
S VIDEO: S-video (separated Y and C)
signals (When HVBK-1505 is
attached)
COMPONENT SD: Component video signals
(When HVBK-1505 is attached)
SDI: SDI video signal
SG: Video test signal
3. AUDIO INPUT SELECT button setting
ANALOG: Analog audio signal
(When HVBK-1505 is attached)
AES/EBU: Digital audio signal in AES/
EBU format
SDI: Digital audio signal in SDI
format
SG: Audio test signal
4. AUDIO VARIABLE switch setting
PRESET : Sets both the REC and PB levels
to the normal level.
REC : Sets the REC audio level of the
channels respectively with the
CH-1/2/3/4 knobs.
PB : Sets the PB audio level of the
channels respectively with the
CH-1/2/3/4 knobs.
1-6
Layout of switch and buttons on the front panel
3. CH1 1/2 button
4. VARIABLE switch
2. VIDEO button
1. i.LINK button

1-7-2. System Adjustment After Installation

Observe the following precautions when this equipment is
used for editing system.
. The REF. VIDEO IN requires video signal which is in
conformity with the RS-170A (525/60).
. Adjust the sync phase of this equipment to the system
sync with [SYNC PHASE] control of the setup menu.
. Adjust the SCH phase of this equipment to the system
SCH with [SUB CARRIER] control of the setup menu.
. When this unit is connected to a switcher that does not
have the sync switching function, the SYNC/BURST
level adjustment is required.
CH2 3/4 button
HVR-1500