Table 4-8
Workstation power connector description (continued)
Item
13
14
15
16
17
18
19
Optical drive (minitower configuration)
This section describes how to remove and install an optical disk drive in a minitower workstation
configuration.
Removing an optical drive (minitower configuration)
1.
Disconnect power from the system
access panel
(Removing the front bezel on page
2.
Disconnect the power (1) and data (2) cables from the optical drive.
Figure 4-37
90
Chapter 4 Removal and replacement procedures
Description
P9
P1
P13
1394 card
P12
Graphics card
P3
(Removing the side access panel on page
Disconnecting the optical drive cables
(Predisassembly procedures on page
64), and then remove the front bezel
68).
58), remove the side
ENWW