4.
Remove the four guide screws from the hard drive and retain them for later use.
Installing a SAS hard drive
1.
Disconnect power from the system
the side access panel
2.
Attach a SAS-to-SATA cable adapter to the connector on the SAS hard drive.
Figure 4-49
3.
Install the four silver, ANSI 6–32 guide screws into the hard drive.
ENWW
(Predisassembly procedures on page
(Removing the side access panel on page
Attaching the SAS-SATA adapter to the SAS hard drive
58), and then remove
64).
Removing and replacing components
97