Communication Setting; Detector Type - Toshiba LF620F Instruction Manual

The following is an example to change the switch position setting from BOTTOM to TOP.
Switch operation
STEP1
STEP2
STEP3
STEP4(=END)

8.2.31 Communication Setting

This setting is needed when optional PROFIBUS or Modbus communication board is installed.
For details, refer to the instruction manual of PROFIBUS or Modbus communication board.
Note: If communication board is not used, this address setting is not needed.

8.2.32 Detector type

Please set Detector type according to the model of the combined detector as shown in the table below.
Detector type
EXC CAL
K-FAC CAL
Note: Please note that this setting influences the instruction.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Display example
P:OTHERS
1 PASSWORD
2 LCD ADJ
3 SW POSN
4 DET TYPE
5 EXIT
ESC
SW POSN
BOTTOM
ESC
SW POSN
BOTTOM
SW POSN
TOP
SW POSN
TOP
SET OK?
ESC
O K
LF410 LF430 LF450 LF470
○ ○ ○ ○
－ 104 －
Description
Select "SW POSN" from the setting item
selection menu.
The current setting (BOTTOM in this
example) appears.
Then push
* Pushing
ESC
screen.
The switches at the bottom change.
(
At the same time, the cursor appears.
(The item indicated by the cursor is
highlighted.)
Then push
You can continue to change the setting item.
Push
items.
: Selected item is scrolled up.
: Selected item is scrolled down.
When the desired item is selected, push
to set the item temporarily.
When you push
to confirm whether the setting is OK or not.
O K
If OK, push
setting, push
N O
ESC
Pushing cancels the setting operation
and exits the setting screen.
N O
Model of detector
LF490 LF654 LF664 GF630
○ ○
○
6 F 8 A 0 9 2 8
.
returns you to the menu
are shown.)
.
to change the selection
, a message appears
. If you want to redo the
.
GF640
○
○