Backspace Character - Motorola V.3400 User Manual

Status Registers
Line Feed Character S4
The standard character is the line feed (ASCII value of 10). This char-
acter is sent by the modem after each status message. To change it, set
S4 as desired (0-127).
Backspace Character S5
The standard character is the backspace (ASCII value of 8). To change
it, set S5 to the desired value (0-127).
Pause Before Dialing S6
When dial tone detection is disabled (command X, X1, or X3 in effect),
the modem waits the number of seconds (0-255) stored in this register
before dialing. The default value is 2 (seconds).
Pause for Ringback and Carrier Detection /
Wait for 2nd Dial Tone S7
If no ringback is detected in the number of seconds in S7 (1-255), the
modem disconnects and sends the NO CARRIER message or code. If
ringback is detected, the modem begins to look for a carrier.
If no carrier is detected within the number of seconds in S7, the modem
hangs up and sends the NO CARRIER message or code.
Values between 1 and 255 may be used. The default value is 30
(seconds).
Pause Interval for Comma S8
When a dial command contains a comma, the modem pauses the
number of seconds in S8.
Change S8 to change the basic pause interval (0-255), or use several
commas in a row for greater delay during dialing.
The default value is 2 (seconds).
Carrier Detect Time S9
S9 contains the amount of time (0-255) in 0.1 second increments the
carrier must be present to be recognized. The default value is 6 (0.6
second). This timer can be extended to lessen the likelihood of false
detection of carrier.
10-6 V.3400