Connection Of Inductive Proximity Switch - Bosch CRS 845 Installation Instructions Manual

4.2

Connection of inductive proximity switch

Sequence:
1. Pull the connecting cables of the inductive proximity switches
B11 and B12 through the distributor box's X10 screwed
cable connection.
2. Join the connecting lines. To do so, use the following Fig. 22
and terminal diagram.
3. After contacting the connecting lines, pull the screwed cable
connection on the distributor box.
EPS
X10
458777-22
Fig. 22 B11-B13 Inductive proximity switch
X10 Distributor box
Terminal diagram
A10
X14
2 3 4
1 5
1 2 3 4 5
1 2 3 4 5
6
1 2 3 4 5 6
X10
1 2 3 4 5 6
1
+ - + - +
B11
B12 B13
22
B11 B12
B13
A10 Control device
X14 Connecting line
X10 Distributor box
B11 Induct. sensor
(drive side)
B12 Induct. sensor
B13 Induct. sensor
(Front side)
7 8 9
7 8 9
2 3
-
4. Join connecting line X14 from the control device to the X10.1
connector of the connecting box X10.
5. Join connecting line from the inductive proximity switch B13
to the X10.2 connector of the connecting box.
6. Route all connecting lines into the cable ducts in the longitu-
dinal member and on the side frame.
B13
Fig. 23
X10.2 X10.1
X14 X10