Toshiba Strata DK 16 Installation And Maintenance Manual page 97

PCOU CONTROLS, INDICATORS, AND INTERFACE CONNECTORS
CONTROL/INDICATOR/
CONNECTOR
(Figure 5-17)
CO Line Circuit 1
Indicator CD112
CO Line Circuit 2
Indicator CD212
CO Line Circuit 3
Indicator CD312
CO Line Circuit 4
Indicator CD412
J1 Connector
J2 Connector
PAD Switch SW101
PAD Switch SW201
PAD Switch SW301
PAD Switch SW401
Program 41
•
Assigns stations access to CO lines (outgoing
only).
Program 42-0, 1-8
•
Assigns behind PBX/CENTREX operation to
each CO line.
Programs 45 ~ 48
•
Defines Toll Restrictions for any CO line.
Programs 50 ~ 56
•
Defines Least Cost Routing using CO lines.
TABLE 5-E
TYPE OF COMPONENT
Red LED
Red LED
Red LED
Red LED
Modular connector
Modular connector
Two-position slide
Two-position slide
Two-position slide
Two-position slide
5-27
INSTALLATION-DK 16 KSU & PCB
DESCRIPTION
Lights to indicate CO line circuit 1 is in
operation (NOTE: CO line indicator will
not light unless PCOU is connected to
a CO).
Lights to indicate CO line circuit 2 is in
operation (NOTE: CO line indicator will
not light unless PCOU is connected to
a CO).
Lights to indicate CO line circuit 3 is in
operation (NOTE: CO line indicator will
not light unless PCOU is connected to
a CO).
Lights to indicate CO line circuit 4 is in
operation (NOTE: CO line indicator will
not light unless PCOU is connected to
a CO).
Interface connector for CO line circuits
1 and 2.
Interface connector for CO line circuits
3 and 4.
Enables 3dB signal level drop for CO line
circuit 1.
Enables 3dB signal level drop for CO line
circuit 2.
Enables 3dB signal level drop for CO line
circuit 3.
Enables 3dB signal level drop for CO line
circuit 4.
Program 78
•
Assigns special ringing of CO lines: Night Ring
Over Page, DISA, IMDU.
Programs 81 ~ 89
•
Assigns CO lines to ring selected stations.
•
Assigns Delayed Ringing to any CO line.
Program 93
•
Assigns names to CO lines.
SECTION 100-816-205
MARCH 1993