General Requirements; Overview Of The Measuring Cycles - Siemens SINUMERIK 840D sl Programming Manual

Measuring variants
2.1

General requirements

2.1.1

Overview of the measuring cycles

Function of the measuring cycles
The following table describes all the measuring cycle functions for the turning and milling
technologies.
Table 2- 1 Measuring cycles
Measuring Description
cycle
CYCLE973 This measuring cycle can be used to calibrate a workpiece
2)
probe on a surface on the workpiece or in a groove.
CYCLE974 This measuring cycle can be used to determine the
2)
workpiece zero in the selected measuring axis or a tool
offset with 1-point measurement.
CYCLE994 This measuring cycle can be used to determine the
2)
workpiece zero in the selected measuring axis with 2-point
measurement. To do this, two opposite measuring points
on the diameter are approached automatically in
succession
CYCLE976 Using this measuring cycle, a workpiece probe can be
calibrated in a calibration ring or on a calibration ball
completely in the working plane or at an edge for a
particular axis and direction.
CYCLE961 This measuring cycle can be used to determine the
position of a workpiece corner (inner or outer) and use this
as work offset.
CYCLE977 This measuring cycle can be used to determine the center
point in the plane as well as the width or the diameter.
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Measuring versions
Calibrate probe - length

Calibrate probe - radius on surface

Calibrate probe - probe in groove

Turning measurement - front edge

Turning measurement - inside diameter

Turning measurement - outside diameter

Turning measurement - inside diameter

Turning measurement - outside diameter

Calibrate probe - length on surface

Calibrate probe - radius in ring

Calibrate probe - radius on edge

Calibrate probe - calibration on sphere

Corner - right-angled corner

Corner - any corner

Edge distance - groove

Edge distance - rib

Hole - rectangular pocket

Hole - 1 hole

Spigot - rectangular spigot

Spigot - 1 circular spigot

2
49