Measuring variants
2.3 Measure workpiece (milling)
Parameters
G code program
Parameters Description
PL
Measuring plane (G17 - G19) -
Calibration data set (1 - 12)
Parameters
Description
Correction
Measuring only (no offset)
target
Work offset (save measured values in an adjustable WO)
Tool offset (save measured values in the tool data)
TR
Name of tool to be corrected
D
Cutting edge number of tool to be corrected
∅
Spigot diameter setpoint
α0
Angle between measuring axis and workpiece
DZ
Infeed distance at measuring height (for G17)
Protection zone
Use protection zone
Yes
No
∅S
Diameter of the protection zone (only for protection zone "Yes")
DFA
Measurement path
TSA
Safe area for the measurement result
Dimensional
Use dimensional tolerance for tool offset
tolerance
Yes
No
TUL
Upper tolerance limit, workpiece (only for dimensional tolerance "Yes")
TLL
Lower tolerance limit, workpiece (only for dimensional tolerance "Yes")
Other parameters and correction targets can be set in the general SD 54760$SNS_MEA_FUNCTION_MASK_PIECE.
1)
140
Unit
-
Machine manufacturer
Please observe the machine manufacturer's instructions.
ShopMill program
Parameters Description
T
Name of the probe
D
Cutting edge number (1 - 9)
Calibration data set (1 - 12)
X
Start point X of the measurement
Y
Start point Y of the measurement
Z
Start point Z of the measurement
1)
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Unit
-
-
-
mm
mm
mm
Unit
-
-
-
mm
Degrees
mm
-
mm
mm
mm
-
mm
mm
Measuring cycles