Measuring variants
2.5 Measure tool (milling)
2.5.3
Measure tool (CYCLE971)
Function
With this measuring version, the tool length or the tool radius of milling and drilling tools can
be measured. A check is made whether the difference to be corrected in the entered tool
length or to the entered tool radius in the tool management lies within a defined tolerance
range:
● Upper limit: Safe area TSA and dimensional difference control DIF
● Lower limit: Work offset range TZL
When this area is maintained, the measured tool length or the tool radius is entered in the
tool management, otherwise a message is output. Violation of the lower limit is not corrected.
Measuring is possible either with:
● stationary spindle (see Section "tool measurement with stationary spindle")
● rotating spindle (see Section "tool measurement with rotating spindle")
Measuring principle
Measure: tool (CYCLE971),
example, length
208
Measure: tool (CYCLE971),
example, radius
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
Measuring cycles