Huawei OptiX OSN 550 Configuration Manual page 278

4 Configuring Ethernet Services
4-124
Parame Value in This Example Description
ter
Hold- VCTRUNK1: 2000
off Time
VCTRUNK2: 2000
(ms)
WTR VCTRUNK1: 300
Time(s)
VCTRUNK2: 300
TSD VCTRUNK1: Disabled
VCTRUNK2: Disabled
Min. VCTRUNK1: 256
Member
VCTRUNK2: 256
s -
Transmi
t
Directio
n
Min. VCTRUNK1: 256
Member
VCTRUNK2: 256
s -
Receive
Directio
n
l Click the Bound Path tab. Click the Configuration button. Set the following in the
Bound Path Configuration dialog box that is displayed. Then, click Apply.
User Paramet
er
User Configura
M ble Ports
Av Lev
aila el
ble
Bo
und
Pat
hs
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OptiX OSN 550 Multi-Service CPE Optical Transmission
In this example, this parameter adopts the
default value 2000. You can set this
parameter according to the expected hold off
time of LCAS switching.
In this example, this parameter adopts the
default value 300. You can set this parameter
according to the expected WTR duration of
LCAS recovery.
In this example, TSD is set to Disabled. In
this case, the LCAS protocol does not
monitor the status of the B3 or BIP bit errors
of a VCTRUNK member.
Sets the min. members - transmit direction.
When the LCAS is enabled and the number
of available members is smaller than this
value, an alarm is reported.
Sets the min. members - receive direction.
When the LCAS is enabled and the number
of available members is smaller than this
value, an alarm is reported.
Value in Description
This
Example
VCTRUN As shown in
K1 EFS8 board is used by the service of user M.
VC12-xv The service of user M uses a 60 Mbit/s
bandwidth. Hence, 30 VC-12s need to be
bound.
For the method of computing the bound
timeslots based on the service bandwidth, see
6.3 Ethernet Service Bandwidths Carried by
VCTRUNKs of Ethernet
Configuration Guide
Figure 4-35, VCTRUNK1 of the
Boards.
Issue 02 (2011-06-30)
System