Tangential Control (T3); Special Response To Signals; Installation Of Compile Cycles (Te01); Simulation Of Compile Cycles (Te02) - Siemens sinumerik 840D sl Function Manual

2.7

Tangential Control (T3)

2.7.1

Special response to signals

The movement of the axis under tangential follow-up control to compensate for a tangent
jump at a corner of the path (defined by the movements of the leading axis) can be stopped
by the following signals (e.g. for test purposes):
• NC Stop and override = 0
• Removal of the axis-specific feed enable
The signals are described in:
References:
/LIS2/ Listen (Book 2)
2.8

Installation of Compile Cycles (TE01)

No signal descriptions required.
2.9

Simulation of Compile Cycles (TE02)

No signal descriptions required.
2.10

Clearance Control (TE1)

2.10.1

Signals to channel (DB21, ...)

DB21, ...
DBX1.4
Edge evaluation: No
Signal state 1 or
edge change 0 → 1
Signal state 0 or
edge change 1 → 0
Special functions: NC/PLC interface signals (Z3)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0
CLC stop
Clearance control is deactivated in the same way as the part program command
CLC_GAIN=0.0.
Clearance control is enabled.
Signal(s) updated: Cyclic
Detailed description
2.7 Tangential Control (T3)
17