Axis Couplings And Esr (M3); Signals To Axis (Db31; Signals From Axis (Db31 - Siemens sinumerik 840D sl Function Manual

Detailed description

2.5 Axis Couplings and ESR (M3)

2.5 Axis Couplings and ESR (M3)
2.5.1

Signals to axis (DB31, ...)

DB31, ...
DBX26.4
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
2.5.2

Signals from axis (DB31, ...)

DB31, ...
DBX98.5
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Signal irrelevant ...
Corresponding to ....
14
Active following axis overlay
Signal(s) updated: Cyclic
An additional traversing motion can be overlaid on the following axis.
This signal is required for the flying synchronization of master and slave axes. Until the
"enable following axis overlay" signal stays set at 1, the following axis selected with
EGONSYN will travel to synchronization in the EG coupling.
Modulo axes included in the EG coupling reduce their position values in the modulo, thereby
ensuring that they approach the next possible synchronization.
The following axis cannot be overlaid and traversed.
If the "enable following axis overlay" signal has not been set for the following axis, the axis
will not travel to synchronization. Instead, the program is stopped at the EGONSYN block and
the self-clearing alarm 16771 is issued until the "enable following axis overlay" signal is set
to 1.
Velocity warning threshold
Signal(s) updated: Cyclic
When the following axis velocity in the axis grouping of the electronic gear (set in machine
data MD32000) reaches or exceeds the velocity % block entered in machine data MD37550,
the signal is set to 1.
The following axis velocity in the axis grouping of the electronic gear is less than the
threshold value described above.
Without electronic gear.
the following machine data:
MD37550 $MA_EG_VEL_WARNING (velocity warning threshold value)
MD32000 $MA_MAX_AX_VELO (maximum axis velocity)
Special functions: NC/PLC interface signals (Z3)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0